MAGNUM PRO MVP-600 Pneumatic Calibration Hand Pump

Magnum Pro Calibration Pumps, the manufacturer of the MAGNUM PRO MVP-600, is based in New York, USA.  Magnum Pro has rapidly become the calibration pump of choice. Their calibration pumps are currently used in over one third of all power plants. The calibration pumps are virtually indestructible and are the only pumps in the industry backed by a two year warranty.

The MAGNUM PRO MVP-600 Pump offers the operator the ability to vent pressure or vacuum either slowly or rapidly. A rapid dump model (MVP-600R) is available upon request.

MAGNUM PRO MVP-600 Specifications:

• Vacuum 28″Hg to pressure 600psi (combination pump)
• Compatible with all gauges and calibrators
• Connections (2 ports) 1/4″ and 1/8″ NPT/BSP
• Weight – 2lbs
• Made in the USA

MAGNUM PRO MVP-600 Features:

• Contoured cushion handles
• Oversized check valve for smooth controlled operation
• Mash proof vent valve (No Needle Valve)
• A patented non-oil based lubricant is used on all moving parts
• Dual O-Rings on all pistons to ensure zero leakage
• 2 year warranty

Points to Remember:

• Insure all gauges and instruments to be calibrated are discon­nected from process pressures before connecting the
  pump. Do not exceed 600 psi (41 bar) as this is the MVP6OO’s maximum pressure.
• The MVP-600 has ‘l/8″ and ‘l/4″ BSP ports. In order to use NPT fittings, the required NPT to BSP parallel thread
  adapters need to be Installed (Adapters are Included)
• Do not use thread sealant paste or tape on the male adapters {Female adapters may be sealed with paste or tape).
  Bonded washers (Included) are required to Insure a proper seal. To seal the adapters, simply hand-tighten and snug
  up with a wrench. Do not over-tighten.
• The MVP-600 utilizes a Schrader valve instead of a needled valve. Thus full open or closed is several turns from the end of the travel. Over-tightening does not increase the seal.